For fixed installation. With TMC connectivity, TMC antenna included. 12/24 Volt.

For fixed installation. With TMC connectivity, TMC antenna included. 12/24 Volt.
The choice for you who want to have your GPS neatly and safely installed! Your GPS will be within easy sight and reach, installed onto the dashboard instead of the windshield giving you clear sight. The holder is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! And by using an active holder, you never have to worry about running out of battery.

The holder has a TMC connector, you easily attach the enclosed TMC antenna to the holder. So the holder provides both charging and TMC connectivity to your device.

12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. Attach onto a ProClip Mounting Platform.

Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot!

Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.

Installation of the holder: Please read all of the instructions and look at the pictures before attaching the holder. 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. 3. Attach the enclosed TMC-antenna to the holder. 4. The holder is in place.